Water Sampler & Flow Meter ​Power Options​

Nickel-Cadmium Batteries

Our nickel-cadmium battery is your best choice where a portable power source is needed in continuous-use applications. It allows more charging cycles than Lead-acid batteries and isn't damaged by overcharging or being left totally discharged for extended periods.

• Maintenance free

• Ruggedly built

• Temperature tolerant
  

Lead-Acid Batteries

Teledyne ISCO's lead-acid batteries are best used wherever portable standby power is required. They have a very low self-discharge rate and outperform nickel-cadmium batteries in applications where battery power is used sporadically over long periods of time. All of our lead-acid batteries are environmentally sealed and maintenance-free. Fluid level checks and refilling are not required.

​​	​ Model 945	​ Model 946	​ Model 948
​Output Voltage	​6 VDC	​11-13.5 VDC	​12 VDC
​Amp/Hour Rating	5.0	​6.5	​45
​Connector Type	​Coiled Wire	​2-pin circular Amphenol	​2-pin circular Amphenol
​Recommended Use	Sites with intermittent or sporadic activity such as stormwater runoff monitoring, inflow and infiltration (I&I) studies, combined sewer overflow CSO monitoring, and more. ​

​High-capacity Power Packs

Our rugged, high capacity power packs safely and reliably convert available AC voltage to DC power.

• Built-in battery charger

• Environmentally sealed
  

​	​ Model 913	​ Model 923
​Input Voltage	​120 VAC 50 or 60 Hz	​240 VAC 50 or 60 Hz
​Output Voltage/Current	​12.5 VDC at 5 A	​12.5 VDC at 5 A
​Connector Type	​2-pin circular Amphenol	​2-pin circular Amphenol
​Recommended Use	​ ​Fixed installation or sites with reliable AC power.

Battery-backed Power Packs

Teledyne ISCO's battery-backed power packs assure that your equipment will keep running even if AC line voltage is interrupted.

• Battery backup

• Benchmark reliability

Amphenol Connector Chargers

An Amphenol connector charger is a low-cost method for charging single Teledyne ISCO batteries. An impact-resistant case and solid-state construction make these chargers almost indestructible.

Clamp-on 12V Chargers

This charger constantly monitors 12 volt/6 Amp charge status, shuts down when charging is complete, and gives notification via LED.

Solar-powered Chargers

Teledyne ISCO's solar-powered chargers deliver energy in long-term applications where AC power isn't available. Units are selected from a variety of solar panel options to best suit your specific application. These chargers are recommended for remote or long-term installations at sites without available AC power.​

​	​Nickel-Cadmium	​Lead-Acid ​ ​ ​
​	Model 934​	​Model 945	​Model 946	​Model 947	​Model 948
​Model 961		​	​	​	​
Model ​963	​	​	​	​	​
​Model 965	​	​	​	​	​
​12 Volt, 6 Amp	​	​	​	​	​
​Model 913		​	​	​	​
​Model 923	​	​	​	​	​
Recommended.  Requires Lantern Battery Charger Adapter. Contact Teledyne ISCO for details.  Requires a connector. Contact Teledyne ISCO for details.

​ 

Documentation

In-depth information can be found within the Power Products Brochure, the Power Products Guide, or by contacting Teledyne ISCO or an authorized Teledyne ISCO representative.​